Table of Contents

• Dataset Description
  • Methods & Sampling
  • Data Processing Description
  • BCO-DMO Processing Description
• Data Files
• Parameters
• Instruments
• Deployments
• Project Information
• Program Information
• Funding

Water column DOC, Chl, PN, PC, PON, POC data from CTD casts

A summary of methods used and detection limits is below under 'Data Processing Description'.

Refer to SAGE Voyage Report

CTD-related instrumentation consisted of:
- a Seabird Electronics (SBE) 911plus CTD with:
- SBE-5 pumped SBE-3 temperature, SBE-4 conductivity and SBE-43 dissolved oxygen
sensors.
- SBE-5 pumped secondary SBE-3 temperature and SBE-4 conductivity sensors.
- Seapoint Sensors, Inc. SCF chlorophyll fluorometer.
- 25-cm Wetlabs C-star transmissometer.
- Biosherical Instruments Inc. photosynthetic ally active radiation (PAR) sensor, model
QSP200L4S.
- Datasonics sonar altimeter, model PSA-900D.
- a SBE 32 24x10-litre Carousel water sampler.
- Ocean Test Equipment Standard BES external-spring Niskin-type water-sampling bottles.
- Salinity sample bottles.
- CTD winch with 10-km 10.5-mm single-core seacable.

Performance: With the exception of issues noted below, the CTD-related instrumentation apparently
functioned to specification and was operated essentially according to accepted practices for the duration of
the voyage. A total of 85 one-cast CTD stations were completed, labelled u3502 to u3743.

PAR Sensor: The initial CTD PAR sensor experienced an intermittent fault that manifested as a time
variable offset, both cast to cast and, less evidently, within casts. It was eventually replaced with a formally
identical spare unit for station u3719 cast 1 and subsequent casts.

Secondary Conductivity Sensor: The initial secondary conductivity sensor eventually developed a clear
fault (during station u3740 cast 1). It was replaced with a formally identical spare unit for station u3740 cast
1 and subsequent casts. The development of this fault was perhaps somewhat progressive, as possibly
indicated by slight shifts in the primary-secondary conductivity difference on casts before station u3740 cast 1.

Water column DOC, Chl, PN, PC, PON, POC data from CTD casts

NIWA HAMILTON INORGANIC CHEMISTRY LABORATORY	
											
CLIENT :Scott Nodder		LOT NUMBER :	2004000218	CHECKED :	MC
NIWA Wellington		        SF NUMBER :	KX 7303		APPROVED :	MC	
JOB NUMBER :	OEBI032		REPORT DATE :	5/10/2006	
JOB :	TAN 0403	
								
A summary of methods used and detection limits is as follows.

Parameter                                                             Description			                                 Detection Limit                     Method	
		
Chlorophyll a(Chla-Av)                            Acetone pigment extraction, spectrofluorometric measurement.		0	A*10200H
Chlorophyll a(Chla-2)                             Acetone pigment extraction, spectrofluorometric measurement.		0	A*10200H
Chlorophyll a(Chla-1)                             Acetone pigment extraction, spectrofluorometric measurement.		0	A*10200H
Chlorophyll a(Chla)                               Acetone pigment extraction, spectrofluorometric measurement.		0	A*10200H
Dissolved Organic Carbon(DOC)                     Dissolved Organic Carbon(low level) using TOC analyser			            100			APHA5310B
Particulate Nitrogen Filter 1(PN-1)		          Catalytic comb @900°C, sep, TCD, CE Instruments C/N analyser		2			MAM, 01-1090	
Particulate Carbon Filter 2(PC-2)		          Catalytic comb @900°C, sep, TCD, CE Instruments C/N analyser		1			MAM, 01-1090
Particulate Carbon Filter 1(PC-1)		          Catalytic comb @900°C, sep, TCD, CE Instruments C/N analyser		1			MAM, 01-1090
Particulate Nitrogen Filter 2(PN-2)		          Catalytic comb @900°C, sep, TCD, CE Instruments C/N analyser		2			MAM, 01-1090
Particulate Organic Carbon Filter 1(POC-1)	      Catalytic comb @900°C, sep, TCD, CE Instruments C/N analyser		1			MAM, 01-1090
Particulate Organic Nitrogen Filter 2(PON-2)	  Catalytic comb @900°C, sep, TCD, CE Instruments C/N analyser		2			MAM, 01-1090	
Particulate Organic Nitrogen Filter 1(PON-1)	  Catalytic comb @900°C, sep, TCD, CE Instruments C/N analyser		2			MAM, 01-1090	
Particulate Organic Carbon Filter 2(POC-2)	      Catalytic comb @900°C, sep, TCD, CE Instruments C/N analyser		1			MAM, 01-1090	
Particulate Phosphorus(PartP-2)			          Acid digest, NH4-N, DRP auto analysis					0.1		Searle
Particulate Phosphorus(PartP-1)			          Acid digest, NH4-N, DRP auto analysis					0.1			Searle
Particulate Nitrogen(PartN-2)			          Acid digest, NH4-N, DRP auto analysis					0.1		    Searle
Particulate Nitrogen(PartN-1)			          Acid digest, NH4-N, DRP auto analysis					0.1			Searle
													
These samples were analysed as received at the laboratory.																	

Generated from original spreadsheet TAN0403_water col_chlPOCPNPPDOC.xls

BCO-DMO Edits
- station_CTD, date, time, lat, lon, SAGEtime and Patch merged in from CTD station data
- 'nd' added to blank cells
- lat/lon for station U740 from position for Northern Biophysical Mooring in voyage report and is approximate
- no date/time for station U740 located to date, date of 20040414 is estimated
- U741 (U3741) has no date, time or position
- U741 (U23741) is in SAGE_watercol_chlPOCPNPPDOC.xls and SAGE_BCODMO_ARCHER_DMS.xls
- U741 (U3741) not found in any other data
- parameter names modified to conform to BCO-DMO convention

While not officially funded as a U.S. SOLAS project, SAGE included
significant U.S. participation and it's science themes were consistent
with those of the International SOLAS program.

[from http://www.us-solas.org:8080/Plone/projects/the-us-solas-in-the-sage-study (26 may 2008)]
SAGE was a mesoscale Fe addition experiment run after the seasonal autumnal
bloom of the sub-Antarctic showed a small biological response to Fe addition.
The SF6/3He dual-tracer experiment extended the range of gas exchange measurement
into stronger wind regimes typical of the Southern Ocean.

A goal of the SAGE project was to increase understanding of air-water Gas Exchange,
Mixed Layer structure, skin/surface properties, biogenic gases and atmospheric fluxes.
Core measurements included Carbon, N2/O2, noble gas, DMS(P), SO2, N2O, CO, CDOM CN
and aerosol chemistry.

One cruise was conducted aboard the Research Vessel Tangaroa and instrumentation
included CARIOCA pCO2 Buoys, Shipboard Gill R3A Anemometer mast, SAMI pCO2 sensors,
SkinDeep vertical profiler, MAERI, SCAMP/TRAMP temperature microstructure profiler,
sparbuoy, ADCP, S-band radar, FRRF, flow cytometer, primary production, nutrients,
Fe, Meteorology and radiosondes.

from "DSR intro.doc"; by Mike Harvey described as in preparation for Deep Sea Research II
The SOLAS air-sea gas exchange experiment (SAGE) was a combined gas-transfer process
study and iron fertilisation experiment conducted in sub-Antarctic waters of the
south-west Bounty Trough (46.5°S 172.5°E) to the south-east of New Zealand between
mid-March and mid-April 2004.

The experiment was designed as a lagrangian study of air-sea gas exchange processes
of CO2, DMS and other biogenic gases associated with an iron-induced phytoplankton
bloom. In conjunction with the iron fertilisation a dual tracer SF6/3He release
served quantify both patch evolution and air-sea tracer exchange at the 10's of km's
scale. Within this patch local/micrometeorological (100's m scale) gas exchange
process studies quantified physical variables such as near-surface turbulence,
temperature microstructure at the interface, wave properties and wind speed to enable
development of improved gas exchange models for the frequently windy Southern Ocean.

After 15 days and four iron additions totalling 1.1 tonne Fe2+ there was a doubling
in both column chlorophyll-a and primary productivity; a very modest response compared
with other mesoscale iron enrichment. An investigation of factors limiting bloom
development considered co-limitation by light, other nutrients, phyto-plankton seed-stocks
and grazing regulation.

Related files

SAGE precruise Science Plan
SAGE precruise Voyage Plan
SAGE Voyage Report
SAGE Release Times
SAGE Surface Physics Metadata Report

SAGE Cruise Track from SST data (.jpg image)
Note:
SAGEtime/Experiment time zero (0.0000) is: 25 March 2004, 19:00 Local Time (NZST) (from SAGE Voyage Report, Voyage Timetable, Pages 5-6)
 

The two main objectives of the Iron Synthesis program (SCOR Working Group proposal, 2005), are:
1. Data compilation: assembling a common open-access database of the in situ iron experiments, beginning with the first period (1993-2002; Ironex-1, Ironex-2, SOIREE, EisenEx, SEEDS-1; SOFeX, SERIES) where primary articles have already been published, to be followed by the 2004 experiments where primary articles are now in progress (EIFEX, SEEDS-2; SAGE, FeeP); similarly for the natural fertilizations S.O.JGOFS (1992), CROZEX (2004/2005) and KEOPS (2005).

2. Modeling and data synthesis of specific aspects of two or more such experiments for various topics such as physical mixing, phytoplankton productivity, overall ecosystem functioning, iron chemistry, CO2 budgeting, nutrient uptake ratios, DMS(P) processes, and combinations of these variables and processes.

SCOR Working Group proposal, 2005. "The Legacy of in situ Iron Enrichments: Data Compilation and Modeling".
http://www.scor-int.org/Working_Groups/wg131.htm

See also: SCOR Proceedings Vol. 42 Concepcion, Chile October 2006, pgs: 13-16 2.3.3 Working Group on The Legacy of in situ Iron Enrichments: Data Compilation and Modeling.

The first objective of the Iron Synthesis program involves a data recovery effort aimed at assembling a common, open-access database of data and metadata from a series of in-situ ocean iron fertilization experiments conducted between 1993 and 2005. Initially, funding for this effort is being provided by the Scientific Committee on Oceanic Research (SCOR) and the U.S. National Science Foundation (NSF).

Through the combined efforts of the principal investigators of the individual projects and the staff of Biological and Chemical Oceanography Data Management Office (BCO-DMO), data currently available primarily through individuals, disparate reports and data agencies, and in multiple formats, are being collected and prepared for addition to the BCO-DMO database from which they will be freely available to the community.

As data are contributed to the BCO-DMO office, they are organized into four overlapping categories:
1. Level 1, basic metadata
(e.g., description of project/study, general location, PI(s), participants);
2. Level 2, detailed metadata and basic shipboard data and routine ship's operations
(e.g., CTDs, underway measurements, sampling event logs);
3. Level 3, detailed metadata and data from specialized observations
(e.g., discrete observations, experimental results, rate measurements) and
4. Level 4, remaining datasets
(e.g., highest level of detailed data available from each study).

Collaboration with BCO-DMO staff began in March of 2008 and initial efforts have been directed toward basic project descriptions, levels 1 and 2 metadata and basic data, with detailed and more detailed data files being incorporated as they become available and are processed.

Related file

Program Documentation

The Iron Synthesis Program is funded jointly by the Scientific Committee on Oceanic Research (SCOR) and the U.S. National Science Foundation (NSF).

The Surface Ocean Lower Atmosphere Study (SOLAS) program is designed to enable researchers from different disciplines to interact and investigate the multitude of processes and interactions between the coupled ocean and atmosphere.

Oceanographers and atmospheric scientists are working together to improve understanding of the fate, transport, and feedbacks of climate relevant compounds, and also weather and hazards that are affected by processes at the surface ocean.

Oceanographers and atmospheric scientists are working together to improve understanding of the fate, transport, and feedbacks of climate relevant compounds.

Physical, chemical, and biological research near the ocean-atmosphere interface must be performed in synergy to extend our current knowledge to adequately understand and forecast changes on short and long time frames and over local and global spatial scales.

The findings obtained from SOLAS are used to improve knowledge at process scale that will lead to better quantification of fluxes of climate relevant compounds such as CO2, sulfur and nitrogen compounds, hydrocarbons and halocarbons, as well as dust, energy and momentum. This activity facilitates a fundamental understanding to assist the societal needs for climate change, environmental health, weather prediction, and national security.

The US SOLAS program is a component of the International SOLAS program where collaborations are forged with investigators around the world to examine SOLAS issues ubiquitous to the world's oceans and atmosphere.

» International SOLAS Web site

Science Implementation Strategy Reports

US-SOLAS (4 MB PDF file)
Other SOLAS reports are available for download from the US SOLAS Web site